Product Category: Solenoid Decoders

YaMoRC's solenoid decoders are specialized for use with heavy duty solenoid turnout motors like SEEP, Gaugemastr and Peco.

YD8008

YD8008

Specially designed to cope with, high-current, solenoid point-motors, the YD8008 is our 8-fold solenoid decoder with intelligent CDU.

It presents the following features:

  • Eight independent 9.5Amp solenoid outputs
  • Smart, 9400 uF CDU, monitoring charge levels for safe and powerful switching
  • Only 380 mA power consumption during charging
  • Very simple basic-setup (base address), by pressing the programming button and switching the desired turnout address
  • No complicated CV settings.
  • Clear-text configuration based upon our new ES-Link technology.
    With our YD9101-Config or YD7100-Command, configuration can be done via built-in web interface. No need for PC-software or Phone/Tablet Apps !
    – or –
    when using the classic Windows PC interface, the YD9100 config-USB-stick as well as our YD6016LN can provide the configuration.
  • Eight address to output mappings, each mapping can a free choice address which can switch any and every output
  • Sequential output activation based upon pulse time and CDU charge level.
  • CDU startup delay adjustable to prevent tripping short circuit protection in boosters
  • Very modest power supply requirements. Even for SEEP/Gaugemaster motors a 15V/500mA wall wart is more than enough.
  • Not suitable for motorized point motors. For these motors, use our YD8116. This also counts for MTB point motors.
  • For two-wire solenoid motors, like Kato, adapter YD6940 should be used.
YD8044

YD8044

Specially designed to cope with, high-current, solenoid point-motors, the YD8044 is our 4-fold solenoid decoder with CDU and Frog Supply.

It presents the following features:

  • Four independent 9.5Amp solenoid outputs
  • Smart, 9400 uF CDU, monitoring charge levels for safe and powerful switching
  • Only 380 mA power consumption during charging
  • Frog polarization through a 2 Amp relay which switches together with the solenoid outputs
  • Very simple basic-setup (base address), by pressing the programming button and switching the desired turnout address
  • No complicated CV settings.
  • Clear-text configuration based upon our new ES-Link technology.
    With our YD9101-Config or YD7100-Command, configuration can be done via built-in web interface. No need for PC-software or Phone/Tablet Apps !
    – or –
    when using the classic Windows PC interface, the YD9100 config-USB-stick as well as our YD6016LN can provide the configuration.
  • Four address to output mappings, each mapping can a free choice address which can switch any and every output
  • Sequential output activation based upon pulse time and CDU charge level.
  • CDU startup delay adjustable to prevent tripping short circuit protection in boosters
  • Very modest power supply requirements. Even for SEEP/Gaugemaster motors a 15V/500mA wall wart is more than enough.
  • Not suitable for motorized point motors. For these motors, use our YD8116. This also counts for MTB point motors.
  • For two-wire solenoid motors, like Kato, adapter YD6940 should be used.