Stepper Motor Extension-Adapter for YD8248
- One Stepper-Motor Interface
- Accepts industry standard Stepper-Drivers e.g. A4988 Driver
- Note ! Driver not included !
Product Category: Accessories
YD8291
Servo Extension-Adapter for YD8248
- 4 extra Servo Outputs
YD8290
Relay Extension-Adapter for YD8248
- 4 independent relays for conventional frog-polarization.
- 2×2 combined relays for power-less frog while moving the servo.
- 4 independent relays for diverse switching tasks.
- a combination of the above.
- 5V relay voltage
- 2A max. Contact Current
YD6940
A set of 2 adapters to connect turnout-motors that require polarity change to operate.
More commonly named as motor- or stall-drives.
Suitable for a.o. motor drives operated on our YD8116:
- Conrad
- Hoffmann
- Tillig
- Fulgurex
- Tortoise
- Cobalt Analog
Also for solenoid drives from Kato, operated on our YD8008 or YD8044
The Adapter can handle currents up to 3A
YD6942
A set of 2 adapters to connect so called Common-Cathode ( minus-return ) signals to our YD8116.
The adapter comes with an onboard 270 Ohms series-resistor.
Thus effectively limiting the output current to about 50-70 mA depending on the supply voltage.
YD9100
The small Configurator Stick for all our modules with ES-PGM-LINK or ES-OUT-LINK interface.
It presents :
- USB interface over virtual COM port with YD-Command for the classic, PC-based configuration software.
- ES-IN-LINK for direct-connection of our ES-xxx-LINK enabled modules ( xxx = OUT or PGM )
- Genuine FTDI USB chip
- Comes with one YD6901 ES-Link Bridge
YD6902ES-EXT
A set of adapters that creates the ES/IO – LINK between modules over CAT 5 Patchcable
YD6901ES-LINK
The actual adapter that creates the ES/IO – LINK between modules